Municipality · Florina

Amyntaio municipality: public map data for property buyers

How often the public forest, flood and Natura 2000 maps come up for cadastral parcels here. These are area figures, not a check of any property.

Data as of 6 November 2026

20.8%

of parcels touch a forest-law code on the forest maps

Greece: 26.0%

20.3%

of parcels intersect at least one official flood map

Florina: 25.7% · Greece: 9.0%

25.7%

of parcels intersect a Natura 2000 site

Florina: 20.9% · Greece: 12.6%

1,607 m²

median parcel size

Greece: 1,251 m²

What the numbers show

The cadastre snapshot holds 68,817 parcels in Amyntaio municipality. The median parcel is 1,607 m² (Florina: 1,838 m²; Greece: 1,251 m²). Each parcel boundary was checked against the official flood maps, the Natura 2000 sites and the forest maps. Every figure below is a share of cadastral parcels that intersect a mapped layer: it shows how often the public maps come up in Amyntaio municipality, not the condition of any property.

19.6% of parcels intersect a high-probability flood hazard zone and 20.3% a medium-probability one (Greece: 7.8% and 8.8%). Counting all four official layers, hazard and risk zones at both probabilities, 20.3% intersect at least one (Florina: 25.7%; Greece: 9.0%). Flood maps come up less often here than in Florina as a whole, but they only cover the river basins that were studied, so a plot outside them can still sit next to a stream.

25.7% of parcels intersect a Natura 2000 site (Florina: 20.9%; Greece: 12.6%), and 25.4% lie mostly inside one. 17.8% intersect a site for habitats and species (SCI/SAC) and 14.3% a Special Protection Area for birds (SPA); one place can be both. Measured by area, 40.9% of the parcel land lies inside a site. Inside a Natura site, many works and some changes of use need an environmental assessment, and the rules depend on the site, so ask a lawyer or civil engineer what applies to a particular plot.

On the public forest maps, 20.8% of parcels touch a code that falls under forest law (Florina: 23.8%; Greece: 26.0%). Forest maps code all land, so a code is a question for your lawyer and engineer, not a conclusion.

Municipality names are shown as published in the official upper-case Greek layer, with a standard Latin transliteration.

The four flood layers

Share of parcelsAmyntaio municipalityFlorinaGreece
Flood hazard zone, high probability19.6%24.7%7.8%
Flood hazard zone, medium probability20.3%25.7%8.8%
Flood risk zone, high probability9.9%20.5%7.4%
Flood risk zone, medium probability10.3%21.3%8.4%
Any of the four20.3%25.7%9.0%

Natura 2000 in detail

Share of parcelsAmyntaio municipalityFlorinaGreece
Intersect any Natura 2000 site25.7%20.9%12.6%
Mostly inside a site (over 50%)25.4%20.7%12.4%
Intersect a site for habitats and species (SCI/SAC)17.8%15.5%7.1%
Intersect a bird protection area (SPA)14.3%13.1%8.5%
Parcel land inside a site, by area40.9%44.2%27.0%

What this does not show

  • Anything about a particular property: ownership, permits, or whether a plot can be built on or used as a rental.
  • Streams, gullies and flood-prone land outside the studied river basins. No flood map is not the same as no flood risk.
  • Which zone of a future Natura decree a plot falls into, or whether a project needs an environmental assessment.
  • Whether a forest map is ratified, still posted or under objection.
  • Parcels missing from the public cadastre snapshot. Areas where the survey is not complete are under-represented.

Method and sources

  • Parcels: Hellenic Cadastre snapshot dated 2 September 2026.
  • Flood maps: the YPEN flood hazard and flood risk zones (Floods Directive, high and medium probability), imported 20 May 2026. Historic flood events: the PFRA register of past floods, imported 21 May 2026.
  • Natura 2000: the YPEN protected-site boundaries, imported 20 May 2026. Municipalities: the Kallikratis boundaries published by YPEKA on data.gov.gr, imported 5 November 2026.
  • Forest maps: the regional files on data.gov.gr (version datagov-202604).
  • A parcel intersects a layer when the overlap is at least 1 m² and at least 1% of the parcel; smaller overlaps are treated as mapping slivers. "Mostly inside" means more than 50%. Overlapping polygons are merged within each parcel before measuring; areas are geodesic.
  • Computed on 6 November 2026. Figures change when any source is updated.